Skip to main content
Skip table of contents

Flow for Solidworks 1.0.3

Issues7 issues

All updates for this release

New Feature

  • SWADDIN-459  Check-in at assembly saves changes to sub model


  • SWADDIN-461  When adding part number balloons to drawing new part number does not blink
  • SWADDIN-460  When adding part number balloons to drawing target parts are marked steadily
  • SWADDIN-434  Classification id can be seen at search result if its description is missing


  • SWADDIN-467  Check-in sets verifier to title block with newer than 0 revision
  • SWADDIN-456  Save as didn't copy all descriptions
  • SWADDIN-440  Part number balloons were not connected to projection view

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.